|
Looking for a reliable fast charger that will handle all your charging
needs? A charger that will reliably peak charge all types of
transmitters, regardless of brand, polarity, or if the transmitter has a
built-in diode? One that will handle all types and sizes of 4- and
5-cell receiver packs, including the new breed of Nickel Metal Hydride
batteries? A charger that you can use to fast peak charge glow drivers
at the field? One that will let you charge both trans- mitter and
receiver packs separately or both at the same time? Hangar 9's new
Double Vision Charger does this--and a whole lot more.
The Double Vision Fast Field Charger is packed with smart features
not found in any other chargers in its class. The Double Vision features
two independent charge circuits: one for charging 9.6-volt transmitter
packs and the other for charging 4.8-volt (4-cell) and 6-volt (5-cell)
receiver packs. Both circuits fast charge at a constant 800mA and
automatically trickle after a fast charge at 80mA.
It takes about 45 minutes to charge a totally dead 600mAh transmitter
or receiver pack. Plus, the Double Vision allows you to independently or
simultaneously charge transmitter and receiver packs. Microprocessor
circuitry insures an accurate peak cutoff every time. The Double Vision
will even charge Nickel Metal Hydride batteries. (Many peak charges
won't because of the soft voltage fallback associated with these cells.)
Two bar graphs on the face of the charger (one for the transmitter
and one for the receiver) display the percentage of charge throughout
the charge cycle. This is extremely useful, as it constantly shows the
charge condition of the batteries. This information can be used for
determining how much the batteries were discharged before charging and
approximately how long it will take before the batteries will be fully
charged.
The Double Vision is unique in that it can charge all brands of
transmitters, regardless of polarity or if the transmitter has a diode
built in. A "TX Polarity" switch located on the charger is switched to
match the correct transmitter used. Choose either the "JR" position for
JR radios or "STD" (standard) for Futaba, Hitec, Airtronics, KO,
Multiplex, or other transmitters. If the switch is accidentally left in
the wrong position and you push the "Charge" button, nothing will
happen. A universal transmitter plug is attached that fits all
transmitters. If the transmitter you are charging has a diode, just push
and hold the "Start" button for 10 seconds and a normal charge cycle
will begin bypassing the diode.
Other features include a glow driver charger that fast charges and
peak detects any single-cell glow igniter, voltmeter jacks that allow
you to monitor the transmitter and receiver voltage, and long 6-foot
input leads that make charging further from the battery source possible.
Plus, the charge is reverse-polarity and fuse-protected.
Small and compact, Hangar 9's Double Vision meets all of your
charging needs. Check out the Double Vision today and see for yourself
why it's the ultimate charger. |
