C-55 Mini High Frequency Electronic Speed Control w/BEC.
For aircraft requiring high current with 500 or 600 size brushed motors
requiring 50A or less.
FEATURES: Compact size to minimize weight
and simplify installation Programmable battery types
Automatic temperature protection reduces max throttle to 70%
when max temperature is reached Uses "Safe-Start" system to
prevent accidental motor starts by disabling the motor
circuitry until the throttle stick is moved to full
throttle, then to the OFF position Factory installed radio,
motor and battery connectors Fully proportional forward with
brake Battery Eliminator Circuitry provides sufficient
current for the receiver and three standard servos. The
motor battery powers the receiver and servos, then when
voltage is reduced to the appropriate voltage, the low
voltage cut-off circuitry stops the motor while continuing
to supply power to the receiver and servos. Solid-state
current overload limiter Built-in thermal shutdown
protection reduces throttle to 70% if the transistors
overheat Reverse-polarity protection High Frequency to
optimize battery run-time and cool operation ON/OFF radio
switch and set-up LED light 180 day limited warranty
INCLUDES: One C-55 Mini Electronic Speed
Control with universal receiver plug installed, installed
motor wires with 4mm gold plated female bullet connectors,
Deans Ultra male battery connector and an ON/OFF switch
Three ceramic capacitors to reduce motor noise. One 2.75"
piece of shrink tubing. One instruction sheet.
REQUIRES: Attaching to motor and setting
up speed control Battery pack Plug universal plug into the
throttle channel on the receiver
SPECS: Length: 1.42" (36mm) Width: .71"
(18mm) Height: .43" (11mm) Weight: 1.22 ounce (35g) with
wires Input: 6-12 NiCd/NiMH cells; 2-4 Li-Po cells Max Rated
Current: 50A continuous BEC Voltage: 5V/1.5A Low Voltage
Cutoff: 0.80V per cell for NiCd/NiMH, 2.75V per cell for
Li-Po Connectors: Universal radio connector, Deans Ultra
male connector, 4mm gold plated female bullet connectors
Switching Frequency: 1.3kHz Motor Size: Speed 500 and 600
brushed only |